Developer forum

Forum » Ecommerce - Standard features » Shipping per quantity

Shipping per quantity

Kurt Moskjær Andersen
Kurt Moskjær Andersen
Reply

I need to have special shipping rules based on the quantity of products.

If the quantity is below a certain number, then use one shipping price and if its higher, use another price. If its higher than ten (10), use free shipping.

I've looked at both the shipping module and the ability to offer order discounts, but cannot find a match.

Do I have to make my own shipping provider, in order to have this functionality?

--
Best regards
Kurt Moskjaer Andersen


Replies

 
Nicolai Pedersen
Reply
This post has been marked as an answer

You can use weight and volume for this. Set one of them to 1 for all products and when weight or volume comes over that amount, apply another shipping fee.

BR Nicolai

Votes for this answer: 1
 
Kurt Moskjær Andersen
Kurt Moskjær Andersen
Reply

Thanks, my thought too.

I will try it.

/Kurt

 
Kurt Moskjær Andersen
Kurt Moskjær Andersen
Reply

Hi Nicolai,

Well, it doesn't behave like I would like it to.

All products have weight set to 1 kg. I would like the shipping to be 250 DKK. below 6 items (kg.) and 937,50 DKK from 7 items. If the total order amount exceeds 5000 DKK., the shipping is free.

Even though all shipping is set to 0 DKK. no matter the number of items (weight) or order amount.

/Kurt

 

Screenshot_5.png Screenshot_6.png
 
Nicolai Pedersen
Reply

Can I see the rest of your shipping setup?

 
Kurt Moskjær Andersen
Kurt Moskjær Andersen
Reply

Like this?

Shipping country is set to Denmark alone.

Screenshot_7.png
 
Kurt Moskjær Andersen
Kurt Moskjær Andersen
Reply

Nicolai, have you had the time to look into it?

 
Nicolai Pedersen
Reply

Hi Kurt

Try to set it to "use lowest fee". Problem is, I think, that both weight is over 7 and order total over 5000. So 2 fees are valid at the same time. So it picks either the cheapest or most expensive one - depending on your setting.

BR Nicolai

 
Kurt Moskjær Andersen
Kurt Moskjær Andersen
Reply

Well, that didn't trigger the calculation, like before.

 

Screenshot_10.png Screenshot_9.png
 
Nicolai Pedersen
Reply

Hi Kurt

Hm, hard to tell without the solution. I've asked the service desk to contact you.

BR Nicolai

 

 

You must be logged in to post in the forum