Developer forum

Forum » Templates » ContentPage.parsed.cshtml Error executing

ContentPage.parsed.cshtml Error executing

Pavlo Rishko
Pavlo Rishko
Reply

installed project like in insturctios and take this error when I'm trying to open any page

 


Replies

 
Shiwanka Chathuranga Dynamicweb Employee
Shiwanka Chathuranga
Reply

end of the 3rd line in the error page, it will show the line number 

if you can post that line, easy for the help 

 
Pavlo Rishko
Pavlo Rishko
Reply


 
Nicolai Pedersen Dynamicweb Employee
Nicolai Pedersen
Reply

Pavlo

It seems like you have installed an empty Rapido - which is fine, but then you have to take the steps described in the documentation to set up a website:

https://doc.dynamicweb.com/rapido/introduction - look in the "New project" section and since you have chosen a complete empty installation, you have to follow the steps for "New website". But as Shiwanka points out, you probably want to go with a version of Rapido that already has a website setup.

I have asked our partner enablement to contact you so you can get a crash course on Dynamicweb and Rapido.

Also consider setting up the solution as described in the documentation instead of as "hit F5" Visual Studio solution.

BR Nicolai

 
Pavlo Rishko
Pavlo Rishko
Reply

It seems, that a big piece of install guideline is out of date.
I think would be great if you update it.

But anyway, at the moment I always have this issue, and I need your help with this issue

 
Pavlo Rishko
Pavlo Rishko
Reply

Nicolai.

Original message by Nicolai Pedersen posted on 30/10/2020 16:34:39:

Pavlo

It seems like you have installed an empty Rapido - which is fine, but then you have to take the steps described in the documentation to set up a website:

https://doc.dynamicweb.com/rapido/introduction - look in the "New project" section and since you have chosen a complete empty installation, you have to follow the steps for "New website". But as Shiwanka points out, you probably want to go with a version of Rapido that already has a website setup.

I have asked our partner enablement to contact you so you can get a crash course on Dynamicweb and Rapido.

Also consider setting up the solution as described in the documentation instead of as "hit F5" Visual Studio solution.

BR Nicolai

 

 
Pavlo Rishko
Pavlo Rishko
Reply

Shiwanka.

Original message by Shiwanka Chathuranga posted on 30/10/2020 16:26:46:

end of the 3rd line in the error page, it will show the line number 

if you can post that line, easy for the help 

 

 
Nicolai Pedersen Dynamicweb Employee
Nicolai Pedersen
Reply

If you say so...

 

You must be logged in to post in the forum